(1) Selection and arrangement of nozzles. When a horizontal boom sprayer sprays herbicides for soil treatment, uniform coverage of droplets is required, and N100 series corundum porcelain slit nozzles are often installed. Usually, the nozzle spacing on the boom is 0.5m. In order to obtain uniform fog distribution, the height of the nozzle from the ground during operation is selected to be 0.5m to achieve uniform fog distribution in the entire spray width. When a horizontal boom sprayer is used for seedling strip spraying, 60 series corundum porcelain nozzles are often installed. The nozzle spacing and the height of the nozzle from the ground during operation can be determined according to the row spacing and height of the crop.
Boom sprayers are mainly used to spray pesticides on crops such as cotton. Therefore, a hollow cone fog nozzle is usually installed at the top of the cotton plant on the horizontal boom to spray from top to bottom. Several identical nozzles are installed on the boom according to the cotton plant conditions. The spray angle can also be adjusted as needed so that the front and back sides of the entire cotton plant can be sprayed with droplets. In this way, a three-dimensional spray is formed to achieve the best effect of pest control.
(2) Determination of the number of nozzles. The number of nozzles is mainly determined based on the discharge volume of the liquid pump under the common working pressure and the spray volume of the nozzle at this pressure. To increase the spray width, select a large-volume nozzle, etc. to change the original design of the sprayer, it is necessary to check whether the number of nozzles used is appropriate. Usually, in order to ensure that the pump return water is stirred, the sum of the spray volume of each nozzle should be less than 88% of the liquid pump discharge volume. That is, the number of nozzles < 0.88 × liquid pump discharge volume / nozzle spray volume (pieces).










