Home > News > Content

Adjustment And Calibration Of Boom Sprayers

Oct 08, 2024

(1) Equipment preparation. Before spraying, prepare the equipment according to the instructions, such as lubricating moving parts, tightening loose screws and nuts, and inflating tires.

(2) Check the shape of the mist flow and the spray volume of the nozzle. Put some water in the liquid tank, start the sprayer in place, spray at the working pressure, and observe the shape of the mist flow of each nozzle. If there is obvious streamline or skewness, the nozzle should be replaced. Then put a small piece of soft plastic tube on each nozzle, put a container underneath, spray at the predetermined working pressure, use a stopwatch to time, collect the mist liquid of each nozzle within 30 to 120 seconds, measure the liquid volume of each sample, and calculate the average spray volume of all nozzles in 1 minute. Nozzles with a spray volume higher or lower than the average value by 10% should have their nozzles replaced.

(3) Calibrate the sprayer. The calibration method is as follows: measure a 50m long field to be sprayed, fill half a tank of water in the liquid tank, adjust the forward speed and working pressure of the tractor, spray water on the measured field, collect the liquid sprayed by one of the nozzles on the 50m long field, weigh or measure the number of grams or milliliters of liquid with a measuring cup, then the actual liquid application amount = 0.2 × spray volume / nozzle spacing (L / hectare), if there are multiple nozzles in a row, L = crop row spacing (m) / number of nozzles in each row.

(4) Change the liquid application amount. If the actual liquid application amount does not meet the requirements, the following three methods can be used to change it: Change the working pressure. Since the pressure needs to be increased by 4 times before the spray volume increases by 1 times, adjusting the pressure too high or too low will change the shape of the mist flow and the size of the droplets, so it is only suitable when the liquid application amount does not change much. Change the forward speed. It is also only suitable when the change in liquid application amount is less than 25%. Change the nozzle model.

Send Inquiry